Riverdi click

From MikroElektonika Documentation
Jump to: navigation, search
Riverdi click
Riverdi click.png
Riverdi click
IC/Module zif20 connector
Interface I2C (SCL, SDA), SPI (SCK, MISO)
Power supply 3.3V, 5V
Website www.mikroe.com/click/riverdi
Schematic Riverdi click schematic


Riverdi click is a simple adapter for connecting Riverdi TFT displays to a mikroBUS™ socket. It features a zif20 connector for interfacing between your target board microcontroller and a FT8xx graphic controller on one of the many available Riverdi displays.

Features and usage notes

Riverdi TFT displays

Riverdi click is solely intended for use with Riverdi TFT displays. There are more than 20 available displays in different sizes, touchscreen options and framing option. The selection is shown here.

I2C/SPI interface

A set of onboard jumpers allow you to switch between I2C and SPI communication lines.

This simple click also has standard click board™ SMD jumpers for switching between a 3.3V and a 5V power supply.

Pinout diagram

This table shows how the pinout on Riverdi click corresponds to the pinout on the mikroBUS™ socket (the latter shown in the two middle columns).

Notes Pin Mikrobus logo.png

mikroBUStm

Pin Notes
NC 1 AN X PWM 16 NC
Reset pin RST 2 RST INT 15 INT Interrupt pin
Chip select CS 3 CS TX 14 NC
SPI Clock SCK 4 SCK RX 13 NC
Master in slave out MISO 5 MISO SCL 12 SCL I2C Clock
Master out slave in MOSI 6 MOSI SDA 11 SDA I2C Data
Power supply +3.3V 7 +3.3V +5V 10 +5V Power supply
Ground GND 8 GND GND 9 GND Ground

Resources